Ive seen people put Moddoo's on the strike bezel on Rotary's.....kind of works ok from what I've seen.
Little one is doing much better these days.. Had a few tests done recently and waiting to hear back.. (Kids do NOT like general anesthesia for things like MRIs.. just saying)
cowsmilk, no but that's on my long list. You might guess it, but I kinda doubt it, as it's not specifically for a HDS. Just 1" lights, and with my penchant for tackin' stuff onto my HDS, I've eyeballed these for a long time.
Jasons clips are not bad either and I really like the Solarforce clip too for the money and it also gives you a lanyard hole!
I put two o-rings in it, Bowman1911. One on either side of the glass, after removing the factory ones. This leaves a thunbnail opening betweeen the bezel and the body. I may take one out...
Removed the outer one and replaced Heny's thin black one. I didn't like the think GITD o-ring on the outside because I think it would get dirty...I put it inside in place of the factory one and tightened it down by hand. It now fills the gap where the factory one sat plus some so that it sticlks out a little...but the bezel is all the way down
Looks good though! Glad my little contribution around here was useful! How's the afterglow? Especially with the 325, you oughta be able to read by the glow for a little bit!
After some further research, I'll correct myself & edit my previous post, the item I've got ordered isn't discontinued after all, so if what I come up with is something ya'll dig, it'll be total obtainable.