Separate names with a comma.
Are you a current member with account or password issues?
Please visit following page for more information
Discussion in 'Show us pics of your EDC!' started by neginfluence04, Oct 3, 2013.
Decided to go behind the grill, I see. I can't imagine keeping them clean is too big of an issue, just hose 'em off and call it good. Are you mounting the 6" Ultras on the rear of the truck?
I'm leaning towards returning the 12" ultra led light bar, and both the 6" ultra led light bars, and buy a 52" for the front and put the 42" on the rear.
Been working on the rust repair
After countless hours of work I finally got that rusted POS looking like new again.
The car looks stylish to me, but the spare tire holder is … “special”
I am always picturing a TÜV or Dekra engineer when you want to have it registered in your papers.
After tons of procrastination I was finally able to get home at a decent time and get the brush guard mounted. Long story short when I first bought the brush guard it was total junk. It was bent, had damage here and there, all the mounting points were rusted, all the mounting hardware was missing, and it was covered in rust but after a lot of TLC we finally got it back to it's former glory. Unfortunately, I haven't found the time to finish the brackets needed to hold all the led lighting but I promise it's coming. I also managed to get the cubes mounted on the windshield wiper cowl so that I can now spot ditches while driving.
These should be in by the end of the week.
Cool truck, man! Congrats!
Sent from my iPhone using Tapatalk
neginfluence04 I've been following the progress on here and I have to say that your truck is awesome!!!
Those Transformer badges are the icing on an incredibly cool cake....
Here are some better pictures of the cubes all mounted up
Ordered these from Daily Grind Fabrications to replace my old warn out factory emblems.
So I finally put my thoughts on paper and have designed what I want my rear bumper to look like. I know when I design it that the swinging rear tire pivot / mount will need to sit slightly below the tail lights so not to obstruct the taillights. I also need to make sure the pivot is moved just slightly right of center under the taillight so that it doesn't obstruct the tail gate.
Thoughts, input, concerns are all welcome.